AP560A: Isolated CAN Bus Interface Module

AP560A: Isolated CAN Bus Interface Module Description

AP560A modules provide four independent CAN bus interface channels. Each channel has a Holt H13111 CAN controller with an ADM3053 transceiver. The advantage of this design is that it has the ability to transmit, receive and perform message filtering on extended and standard messages.

This module offers an effective solution for avionics and other applications implementing the CAN 2.0A/B specification. The controller is configurable to comply with both the ARINC 825 and CAN aerospace standards. High channel density and high-level isolation make this rugged module well-suited for use in a variety of challenging environments.

The AcroPack CAN module is RoHS compliant and ideal for the following applications:

• Avionics and aerospace
• Defense vehicles
• Marine control and navigation systems

The AcroPack® product line updates our popular Industry Pack I/O modules with a PCIe interface format. This tech-refresh design offers a compact size, low-cost I/O, the same functionality of the existing Industry Pack modules and a rugged form factor.

The AP560A modules are 70mm long, 19.05mm longer than the full length mini PCIe card. The board’s width is the same as mPCIe board and use the same mPCIe standard board hold down standoff and screw keep out areas.

A down facing 100 pin Samtec connector will mate with the carrier card. Fifty of these signals are available as field I/O signals.

Performance Specifications

Power

* Idle current draw was measured with no external loopbacks or termination installed and no active communication on any port.
** Max is with all four ports transmitting at 1Mbps.

CAN Bus

Configuration: Four independent CAN bus channels.Holt H13111 CAN controller with ADM3053 transceiver.

ISO 11898 standard: Supports the standard data and remote frame as well as the extended data and remote frame according to CAN specification 2.0 Part A and Part B.

Isolation: 1kV DC isolation.

Maximum data rate: 1Mb/S.

PCI Express Base Specification

Conforms to PCIe base specification: Revision 2.1.

Lanes:1 lane in each direction.

Bus Speed: 2.5 Gbps (Generation 1).

Memory: 2K space required.1 base address register.

Environmental

Operating temperature: -40 to 71°C. 65 to 71°C. Temperatures above 65°C will require a heatsink model AP-CC-01.

Storage temperature: -55 to 125°C.

Relative humidity: 5 to 95% non-condensing.

Operating Vibration: Designed to comply with IEC 60068-2-64: 10-500Hz, 5G-rms, 2 hours/axis.

Operating Shock: Designed to comply with IEC 60068-2-27: 30G, 11ms half sine, 50G, 3mS half sine, 18 shocks at 6 orientations for both test levels.

EMC Directive: Conforms to EMC Directive 2004/108/EC.

Physical

Length 70mm.

Width: 30mm.

Additional information