Click to zoom
$530$660
Clear
Product short description:
  • 40 low-side switch output channels
  • 0-60V DC output range
  • High output current (up to 1A per channel)
RSS
FACEBOOK
FACEBOOK
TWITTER
Visit Us
LINKEDIN

The IP405 controls up to 40 low-side switches (open-drain MOSFETs).

Operation of this module is very simple. Writing a “0” bit to a channel data register opens the switch to turn off a field device. Similarly, writing a “1” bit closes the switch to turn on the device. Each register can be read back to verify the value. Loopback monitoring of critical control signals is easily accomplished by reading back output states using Acromag’s IP400 Digital Input Module.

To ensure safe, reliable control under all conditions, the output operation is “fail-safe.” That is, outputs are always off on power-up and are automatically cleared following a system software reset.

Specifications

Digital Outputs

Output channel configuration: 40 open-drain DMOS MOSFETs with common source connection.
Voltage range: 0 to 60V DC, maximum.
Output ON current range: 0 to 1A DC, continuous (up to 10A total for all channels combined), 250mA DC, continuous (all channels on). No deration required at elevated ambients.
Turn on time: 320nS typical (varies with load).
Turn off time: 500nS typical (varies with load).

IP Compliance (ANSI/VITA 4)

Meets IP specifications per ANSI/VITA 4-1995.
IP data transfer cycle types supported: Input/output (IOSel*), ID read (IDSel*).
Access Times (8MHz clock): All functions: 0 wait states (250nS cycle), except Channel register write: 1 wait state (375nS cycle).
Updates: Requires two 16-bit and one 8-bit writes to update all channels.

Environmental

Operating temperature: 0 to 70°C (IP405) or -40 to 85°C (IP405E model).
Storage temperature: -55 to 125°C (all models).
Relative Humidity: 5 to 95% non-condensing
MTBF: 901,313 hrs at 25°C, MIL-HDBK-217F, Notice 2.
Power:
+5V (±5%): 350mA maximum.
+12V (±5%) from P1: 8.5mA maximum.
-12V (±5%) from P1: 0mA (not used).

  • 40 digital low-side switch outputs
  • 0 to 60V DC output range
  • High output current (up to 1A per channel)
  • True logic operation
  • Low drain-to-source ON resistance
  • Failsafe power-up and system reset (open outputs)
  • Output state readback capability (built-in)
  • 0 to 70°C (IP405) or -40 to 85°C (IP405E model)
  • Latched buffers enable the user to read back the output channel registers for verification purposes.
  • Loopback monitoring (with IP400) enables self-test and diagnostics to detect system faults.
  • Low drain-to-source ON resistance ensures TTL logic-low compatibility at high currents and reduces power dissipation.
  • Individual channels sink up to 1A DC continuous. No deration of output current required at high ambient temperatures.
IPSW-API-LNX (Log in to download the file)
  • Compare

    502x Cable Series

    • Communication Signal Cables
    • Wide assortment of ribbon cables
    $40$600
    Select options
  • Compare

    IPSW-API: I/O Function Routines for VxWorks, Windows, Linux

    • Use with IndustryPack modules/carriers
    • Easy installation procedure
    • Help files with step-by-step instructions
    • Demonstration Program
    • Driver level support for desktop and embedded Windows level programming environments
    $365$1,005
    Read more
  • Compare

    Termination Products

    • DIN rail-mount panels
    • 50 screw terminals on 50-pin connector termination panels
    • 50 screw terminals on SCSI-2 connector termination panels
    • 68 screw terminals on SCSI-3 connector termination panels
    $165$210
    Select options
  • Compare

    Transition Modules

    • Various transition modules
    $220$890
    Select options

Additional information

Weight N/A
Dimensions N/A
Part Number

TRANS-200: Use with AVME9670 & AVME9670E, TRANS-C100: Use with AcPC8635, TRANS-C200: Use with ACPC8625, XBRD-9060-LF: Expansion I/O Carrier Module, XVME-9640-1-LF: Transition Module with P0 connector, XVME-9640-2-LF: Transition Module without P0 connector, TRANS-C4610: Use with AcPC4610, TRANS-C4620: Use with AcPC4620E and AcPC4620CC, TRANS-C5200: Use with AcPC4620E and AcPC4620CC with 128 CMOS I/O, TRANS-C5201: Use with AcPC4620E and AcPC4620CC with 64 EIA485 I/O channels, TRANS-C5210: Use with AcPC8625, VPX4500-RTM-LF: Use with VPX4500E-LF and VPX4500-CC-LF, TRANS-V112-LF: Rear transition module for the VPX4812 / VPX4814

  • Description

    These adapters repeat field I/O connections on Acromag’s carrier cards for front or rear exit from the card cage.

    Transition modules provide a solution for controlling the location of your cabling within the card cage.

    TRANS-200: Transition module
    Transition module for AVME9670 board. See AVME9670 manual for more information.

    VPX4500-RTM-LF: Rear transition module used with both the VPX4500E-LF and the VPX4500-CC-LF carriers to provide access to the slot C AcroPack field I/O signals. See carrier card user manual for more information

     

     

  • Features & Benefits

    • 40 digital low-side switch outputs
    • 0 to 60V DC output range
    • High output current (up to 1A per channel)
    • True logic operation
    • Low drain-to-source ON resistance
    • Failsafe power-up and system reset (open outputs)
    • Output state readback capability (built-in)
    • 0 to 70°C (IP405) or -40 to 85°C (IP405E model)
    • Latched buffers enable the user to read back the output channel registers for verification purposes.
    • Loopback monitoring (with IP400) enables self-test and diagnostics to detect system faults.
    • Low drain-to-source ON resistance ensures TTL logic-low compatibility at high currents and reduces power dissipation.
    • Individual channels sink up to 1A DC continuous. No deration of output current required at high ambient temperatures.
  • Specs & Data Sheets

  • Software

    IPSW-API-LNX (Log in to download the file)
  • Accessories

    • Compare

      502x Cable Series

      • Communication Signal Cables
      • Wide assortment of ribbon cables
      $40$600
      Select options
    • Compare

      IPSW-API: I/O Function Routines for VxWorks, Windows, Linux

      • Use with IndustryPack modules/carriers
      • Easy installation procedure
      • Help files with step-by-step instructions
      • Demonstration Program
      • Driver level support for desktop and embedded Windows level programming environments
      $365$1,005
      Read more
    • Compare

      Termination Products

      • DIN rail-mount panels
      • 50 screw terminals on 50-pin connector termination panels
      • 50 screw terminals on SCSI-2 connector termination panels
      • 68 screw terminals on SCSI-3 connector termination panels
      $165$210
      Select options
    • Compare

      Transition Modules

      • Various transition modules
      $220$890
      Select options
  • Additional information

    Additional information

    Weight N/A
    Dimensions N/A
    Part Number

    TRANS-200: Use with AVME9670 & AVME9670E, TRANS-C100: Use with AcPC8635, TRANS-C200: Use with ACPC8625, XBRD-9060-LF: Expansion I/O Carrier Module, XVME-9640-1-LF: Transition Module with P0 connector, XVME-9640-2-LF: Transition Module without P0 connector, TRANS-C4610: Use with AcPC4610, TRANS-C4620: Use with AcPC4620E and AcPC4620CC, TRANS-C5200: Use with AcPC4620E and AcPC4620CC with 128 CMOS I/O, TRANS-C5201: Use with AcPC4620E and AcPC4620CC with 64 EIA485 I/O channels, TRANS-C5210: Use with AcPC8625, VPX4500-RTM-LF: Use with VPX4500E-LF and VPX4500-CC-LF, TRANS-V112-LF: Rear transition module for the VPX4812 / VPX4814