The Embedded Computing and I/O Solutions division is focused on high-performance processors, FPGA boards, and I/O products for applications that demand rugged high-performance precise operation.

Showing 1–16 of 23 results

  • Compare

    AVME9660A: VMEbus 6U Carrier

    • Non-intelligent VME IP carrier
    • Holds four IP modules
    • 50-pin front panel header connectors
    • Supports two interrupt channels per IP
    • Standard IP module interface
    The AVME9660A is a non-intelligent slave board that interfaces Industry Pack (IP) modules to the VMEbus.
    Select options
  • Compare

    IP500A: Serial Communication, 232 Industry Pack Module

    • Four asynchronous EIA/TIA-232E serial ports
    • 16-byte FIFO buffers
    • Interrupt support
    • Programmable baud rate (up to 128Kbps)
    Select options
  • Compare

    IP560: CAN Bus Interface Industry Pack Modules

    • Two CAN bus channels with optional isolation
    • NXP SJA1000 CAN controller with TJA1043 transceiver
    Select options
  • Compare

    IP570: MIL-STD-1553 Bus Interface Modules

    • One or two 1553 interface channels
    • DDC Micro-ACE controls 1553 interface
    Select options
  • Compare

    ACEX-4600-EDK: Engineering Design Kit

    The ACEX-4600-EDK is an engineering development kit to be used with the ACEX-4620/ACEX-4610 Type 6 COM Express Carrier boards. It provides access to all Type 6 COM Express peripherals via industry standard connectors.
    Select options
  • Compare

    APC-PMC: Non-intelligent PMC Carrier Card

    • Half-length PCI card
    • Holds one PMC card
    • 32-bit 66 MHz PCI interface
    This board provides an easy and low cost solution that enables use of a PMC mezzanine I/O module in a standard PCI computer system. The carrier card acts simply as an adapter to route PCI bus signals to and from the PMC module through the PCI card slot edge connector.
    Select options
  • Compare

    APC8620A: Non-intelligent PCI Bus Carrier for IP Modules

    • Holds five IP modules
    • Front access I/O
    • Plug-and-play carrier configuration and interrupt support
    This board interfaces industry-standard Industrial I/O Pack (IP) modules to a PCI bus on a PC-based computer system.
    Select options
  • Compare

    APC8621A: Non-intelligent PCI Bus Carrier, Half-Length

    • Nonintelligent PCI bus carrier
    • Holds three IP modules
    • Plug-and-play carrier configuration and interrupt support
    • Two interrupt channels per IP module
    • Supervisory circuit reset generation
    This board interfaces industry-standard Industrial I/O Pack (IP) modules to a PCI bus on a PC-based computer system. The half-length card is ideal for use in smaller PC chassis.
    Select options
  • Compare

    AVME9668: VMEbus 6U Carrier

    • Non-intelligent VME IP carrier
    • Holds four IP modules
    • Front panel SCSI-2 connectors
    • Supports 8MHz and 32MHz IP clocks
    • Supports two interrupt channels per IP
    Consult factory for long-term availability. The AVME9668 is a non-intelligent slave board that interfaces IP modules to the VMEbus.
    Select options
  • Compare

    AVME967xA: VME64 Carriers with Optional Geographical Addressing

    • Non-intelligent VME64x IP carrier
    • Holds two or four IP modules
    • VME64 high-density rear connectors
    • Geographical or user-defined addressing
    The AVME9670A and AVME9675A are non-intelligent slave boards that interface up to four IP modules to the VMEbus.
    Select options
  • Compare

    Fans & Cooling

    • Fans for use in air-cooled applications
    • Conduction-cooled kits
    • Heatsinks
    Select options
  • Compare

    Hardware

    • Conduction cooling kit
    • Front panels
    • MIL-STD power filter
    Select options
  • Compare

    IP480: Counter/Timer Module

    • Two or six 16-bit (one or three 32-bit) counter/timer channels
    • Event counter
    • Output waveform generator
    • Pulse-width or periodic rate monitor
    • Watchdog timer with isolated relay output
    • Interrupt support
    Consult factory for long-term availability.    
    Select options
  • Compare

    IP501: Serial Communication, 422/485 Full Duplex Industry Pack Module

    End of Life. Consult factory for alternative solutions.
    • Four asynchronous EIA/TIA-422B (EIA-485) serial ports
    • FIFO buffers (16 or 64-byte)
    • Interrupt support
    • Programmable baud rate (up to 512Kbps)
    Select options
  • Compare

    IP502: Serial Communication, 485 Half-Duplex Industry Pack Modules

    • Four asynchronous EIA-485 serial ports
    • 16-byte FIFO buffers
    • Interrupt support
    • Programmable baud rate (up to 512Kbps)
    Consult factory for long-term availability.
    Select options
  • Compare

    IP511: Serial Communication, 422 Isolated Industry Pack Module

    • Four asynchronous EIA/TIA-422B isolated serial ports
    • 16 or 64-byte FIFO buffers
    • Interrupt support
    • Programmable baud rate (up to 512Kbps)
    Consult factory for long-term availability.
    Select options

Embedded I/O Processing Solutions

Acromag’s embedded I/O boards and mezzanine modules are ideal for embedded computer and high-performance control systems. Select from VPX, PCI, CompactPCI, VME, mini PCIe-based AcroPack®, Industry Pack, VPX, XMC and PMC cards to perform a broad range of analog, digital, counter/timer I/O and serial and Ethernet communication functions.

Mini PCIe-based AcroPack®, Industry Pack, VPX, XMC and PMC mezzanine embedded I/O modules plug into VPX, PCI, PCIe, CompactPCI, and other carrier cards to perform A/D, D/A, DIO, counter/timer, communication and other functions.

Acromag embedded I/O boards offer an unmatched balance of features, performance, and price for the best values in embedded I/O. These boards are based on technology and circuit designs with time-tested reliability in thousands of installations.

Real-Time Control Systems