Application Note: Ethernet I/O Simplifies Communication Between One PLC and Multiple Remote Locations
This document illustrates using Acromag's BusWorks® XT Ethernet I/O modules to split one signal from a central control room PLC and control multiple remote locations using Ethernet protocol.
Defining the Problem:
A customer has multiple remote locations linked over an Ethernet network, each requiring discrete outputs. They all need to be sent the same communication signal at the same time.
• All remote sites need to be controlled simultaneously from one central control room via Ethernet protocol
|Implementing the Solution:||Featured Products:|
|1. Set up the Ethernet comunication between master
PLC device and the BusWorks XT discrete I/O modules (XT1111)
|• 16-Channel Discrete I/O, Modbus/TCP XT1111-000|
|2. Connect the field instruments and verify input
status using the software test & polling feature
|• 16-Channel Discrete I/O, with Counter/Timers 989EN-4016|
|3. Program the BAS with the remote I/O network
parameters and Modbus registers.
|• Software Interface Package XT-SIP|
Our BusWorks XT Modbus/TCP remote I/O modules include a peer-to-peer feature known as i2o, where two or more slaves can talk to each other without requiring a master. With i2o communication, one signal from the PLC is split by the XT1111 modules and sent to multiple locations. The XT1111 automatically re-transmits the discrete level to each 989EN module's IP address, thus reproducing the status of the original PLC input.