Ribbon, SCSI, serial, and parallel communication signal cables
Acromag provides a large selection of signal cables to complete the connection of the field wiring on the termination panel to the I/O board. We offer you a wide assortment of ribbon cables to accommodate the various pin and connector configurations. Cables range from simple 50-pin headers (shielded or unshielded) to high-speed SCSI cables. Cable support is available for all of Acromag’s analog I/O, digital I/O and serial communication boards.
Features & Benefits
CABLE: MODEL 5028-187 (SCSI-2 to Flat Ribbon, Shielded)
Type: Round shielded cable, 50-wires (SCSI-2 male connector at one end and a flat female ribbon connector at the other end). The cable length is 2 meters (6.56 feet). This shielded cable is recommended for all I/O applications (both digital I/O and precision analog I/O).
Application: Used to connect Model 5025-552 termination panel to the TRANS-200 Transition Module. The transition module then connects to all four IP module slots to the rear of the AVME9670 or AVME9675-4 (Slots A-D). The AVME9675-2 uses IP slots A-B.
Length: Standard lenght is 2 meters (6.56 feet). Consult factory for other lenghts. It is recommended that this length be kept to a minimum to reduce noise and power loss.
Cable: 50 conductors, 28 AWG on 0.050 inch centers (permits mass termination for IDC connectors), foil/braided shield inside a PVC jacket.
Connectors: (One End): SCSI-2, 50-pin male connector with backshell and spring latch hardware. (Other End): IDC, 50-pin female connector with strain relief.
Keying: The SCSI-2 connector has a “D Shell” and the IDC connector has a polarizing key to prevent improper installation.
Schematic and Physical Attributes: See Drawing 4501-758.
Electrical Specifications: 30 VAC per UL and CSA (SCSI-2 connector spec.’s). 1 Amp maximum at 50% energized (SCSI-2 connector spec.’s).
Operating Temperature: -20ºC to +80ºC.
Storage Temperature: -40ºC to +85ºC.
Shipping Weight: 1.0 pound (0.5Kg), packed.